TCA Throttle With Fenix

[Zimmerbz 168]

I just installed the TCA quadrant.  The sim recognizes the throttle and sees the movements when  in the controls page, but not when I am in the Fenix.  Is there a step I missed.  I know i need to go into the MCDU to calibrate, but the lever isn't moving in the sim.  Any thoughts?  The spoiler axis works, engine start, parking brake and gear works but not the flaps .  Any help would be apprecitated

Edited October 29, 2022 by Zimmerbz

[SierraDelta 1,383]

12 minutes ago, Zimmerbz said:

Any thoughts? 

Read this - all of it, and watch the video:

https://kb.fenixsim.com/setup-tca-throttle

[Zimmerbz 168]

16 minutes ago, SierraDelta said:

Read this - all of it, and watch the video:

https://kb.fenixsim.com/setup-tca-throttle

THanks.  I got it working now.  I appreciate it

[Zimmerbz 168]

The only thing I couldn’t get working were the engine switches.  They kept flickering on and off.  Any cause for that?  The ignition switch to be more specific.  In the VC it always goes back from start

Edited October 30, 2022 by Zimmerbz

[Swe_Richard 1,175]

1 hour ago, Zimmerbz said:

The only thing I couldn’t get working were the engine switches.  They kept flickering on and off.  Any cause for that?  The ignition switch to be more specific.  In the VC it always goes back from start

I have that behaviour too. Checked for dual assignment but had none so I am stumped. 

Edited October 30, 2022 by Swe_Richard
Spelling

[F737MAX 5,938]

I found that my TCA TQ no longer worked the way I expected after cleaning out some residual USB device files from my PC.
Going through the whole firmware update install made everything work as it should.
 

 

[Matt Webb 172]

7 hours ago, Swe_Richard said:

I have that behaviour too. Checked for dual assignment but had none so I am stumped. 

Me to.   It seems too only happen when to move the switch to IGN and then look around using the right mouse button.    (i.e It flicks back to NORM whenever I press the right mouse button).

Clearing the right button mouse assignment "Toggle External View Freelook (Hold)" stops this behavior, but that's of course not a viable solution

Edited October 30, 2022 by Matt Webb

[ConstVoid 112]

13 hours ago, Matt Webb said:

It seems too only happen when to move the switch to IGN and then look around using the right mouse button. 

It's been reported that you can use the middle mouse button without causing this problem, but I've never tried it and don't know what the assignment is, as I'm not near my FS PC at the moment.

[Matt Webb 172]

1 hour ago, ConstVoid said:

It's been reported that you can use the middle mouse button without causing this problem, but I've never tried it and don't know what the assignment is, as I'm not near my FS PC at the moment.

Thanks!  Might give this a go!